Honda ADV150 2019 User Manual

Removing & Installing Body Components
Battery
#
Removal
Make sure the ignition switch is in the
(Off) position.
1. Remove the battery cover. 2 P. 83
2. Unhook the rubber strap.
3. Disconnect the negative - terminal from
the battery.
4. Disconnect the positive + terminal from
the battery.
5. Remove the battery taking care not to
drop the terminal nuts.
#
Installation
Install the parts in the reverse order of removal.
Always connect the positive + terminal first. Make
sure that bolts and nuts are tight.
Make sure the clock information is correct
after the battery is reconnected. 2 P. 24
The anti-theft alarm system will be
deactivated if the battery is disconnected.
The system will remain off when the battery is
reconnected.
To activate the system, turn the ignition switch to
the (On) position once.
For proper handling of the battery, see
“Maintenance Fundamentals.” 2 P. 72
“Battery Goes Dead.” 2 P. 122
20191017191217_32K0WC000_eng_BOOK Page 85 Thursday, October 17 2019 19:17:25 JST
Maintenance
82
Positive terminal
Rubber strap
Battery
Negative terminal

Honda ADV150 2019 Specifications

General

Displacement	149.3 cc
Bore x Stroke	57.3 mm x 57.9 mm
Compression Ratio	10.6:1
Fuel System	PGM-FI (Programmed Fuel Injection)
Ignition System	Full Transistorized Ignition
Starting System	Electric
Front Suspension	Telescopic Fork
Front Brake	Hydraulic Disc
Rear Brake	Mechanical Drum
Front Tire	110/80-14
Rear Tire	130/70-13
Length	1, 950 mm
Width	763 mm
Height	1, 153 mm
Seat Height	795 mm
Wheelbase	1, 324 mm
Ground Clearance	165 mm
Curb Weight	133 kg
Engine Type	Liquid-cooled, 4-stroke, SOHC
Transmission	Automatic, V-Matic
Rear Suspension	Twin Shock
Fuel Tank Capacity	8.0 L