630
uu
Fuses
u
Inspecting and Changing Fuses
Inspecting and Changing Fuses
1. Turn the ignition switch to LOCK (0
*1
. Turn
headlights and all accessories off.
2. Remove the fuse box cover.
3. Check the large fuse in the engine
compartment.
u If the fuse is blown, use a Phillips-head
screwdriver to remove the screw and
replace it with a new one.
4. Inspect the small fuses in the engine
compartment and the vehicle interior.
u If there is a blown fuse, remove it with
the fuse puller, and replace it with a new
one.
*1: Models with the smart entry system have an ENGINE START/STOP button
instead of an ignition switch.
1Inspecting and Changing Fuses
Replacing a fuse with one that has a higher rating
greatly increases the chances of damaging the
electrical system.
Replace fuse with a spare fuse of the same specified
amperage.
Confirm the specified amperage using the charts on
P. 627 to 629.
Use the charts to locate the fuse in question and
conform the specific amperage on the fuse label.
2 Fuse Locations P. 627
There is a fuse puller on the back of the engine
compartment fuse box cover.
17 CR-V-31TLA6000.book 630 ページ ２０１６年１２月１５日 木曜日 午後４時２７分
To Next Page
Loading...
Need help?
General
