5.4.7 UNBLOCKING THE COLLECTOR CHANNEL
Cutting very tall or wet grass, particularly at too high speed, can cause the collec-
tor channel to become blocked. Should this happen, it will be necessary to:
– stop forward movement immediately, disengage the blades, stop the engine
and remove the key;
– take off the grass-catcher or stone-guard;
– remove the accumulated cuttings, reaching them from the outlet of the collector
channel.
This job must only be performed with the engine turned
off.
5.4.8 “M
ULCHING” FUNCTION (OPTIONAL)
The “Mulching” cap recycles grass inside the
cutting deck, chopping it into fine strands and
strewing them evenly on the lawn.
This accessory must be fastened to the rear
plate and used as shown in the relevant
instructions.
5.4.9 E
ND OF MOWING
When you have finished mowing, disengage the blades, lower the engine speed
and return with the cutting deck in the highest position.
5.4.10 E
ND OF WORK
Stop the machine, put the accelerator lever in the «SLOW» position and turn off
the engine by putting the key into the «OFF» position.
This operation makes the fuel valve automatically close.
Always take out the ignition key if leaving the machine
unattended!
!
WARNING!
!
WARNING!
EN 32 HOW TO USE
To Next Page
Loading...
Need help?
General
