EN 36 HOW TO USE
Take care when beginning forward movement on sloping
ground to prevent the risk of tipping up. Reduce the forward speed before
going on a slope, particularly downhill.
Never use reverse to reduce speed going downhill. con-
trol of the machine may be lost, particularly on slippery surfaces.
Never ride the machine on slopes in neutral gear or
with the clutch out! Always engage a low gear before leaving the
machine stopped and unattended.
Go down slopes without touching the pedal (☛ 4.32/33) to take advantage of
the braking effect of the hydrostatic drive when the transmission is not
engaged.
5.6 TRANSPORTING
If the machine must be transported on a lorry or trailer
car, use access ramps having proper strength, width and length. Load the
machine with the engine turned off, without driver and only pushed by a
proper number of people. Lower the cutting deck, engage the parking
brake and properly secure the machine to the means of transportation
with cables or chains during transportation.
5.7 ADVICE ON HOW TO OBTAIN A GOOD CUT
1. To keep a lawn green and soft with a good appearance, it should be cut regu-
larly and without damaging the grass.
2. It is always better to cut the grass when dry.
3. The blades must be in good condition and well sharpened so that the grass is
cut straight without any ragged edge that leads to yellowing at the ends.
!
WARNING!
HF2•••HTEHF2•••HME
➤
!
DANGER!
HF2•••SBE
➤
!
DANGER!
!
WARNING!
To Next Page
Loading...
Need help?
General
