EN 37HOW TO USE
4. The engine must run at full speed, both to ensure a sharp cut of the grass and
to get the necessary thrust to push the cuttings through the collector channel.
5. The frequency of mowing should be in relation to the rate of growth of the
grass, which should not be left to grow too much between one cut and the next.
6. During hot and dry periods, the grass should be cut a little higher to prevent
the ground from drying out.
7. If the grass is very tall, it should be cut twice in a twenty-four hour period. The
first time with the blades at maximum height, possibly reducing the cutting width,
and the second cut at the desired height.
8. The appearance of the lawn will improve if you alternate the cutting in both
directions.
9. If the collector system tends to get blocked
with grass, you should reduce the forward
speed since this may be too high for the condi-
tion of the grass. If the problem persists, the
probable causes are either badly sharpened
blades or deformed wings.
10. Be very careful when mowing near bushes
or low kerbs which could distort the horizontal
position and damage the edge of the cutting deck as well as the blades.
5.8 SUMMARY OF THE MAIN OPERATIONS TO BE CARRIED OUT IN VARI-
OUS CONDITIONS OF USE
To ...
Start the engine (☛ 5.4.1)
Go forward (☛ 5.4.2)
Brake or stop (☛ 5.4.3)
Reverse (☛ 5.4.4)
You will need to ...
Ensure that all the conditions allowing starting are met,
and then turn the key.
Move the accelerator;
: push the pedal right down, engage the
gear (☛ 4.22) and then gradually release the pedal;
: press the drive pedal forward (☛
4.32);
Reduce the engine speed and press the brake pedal.
Stop the machine;
: put into neutral (N), push the pedal right
down, engage reverse, (☛ 4.22) and then gradually
release the pedal;
: press the drive pedal in reverse;
(☛ 4.33).
HF2•••HTEHF2•••HME
➤
HF2•••SBE
➤
HF2•••HTEHF2•••HME
➤
HF2•••SBE
➤
To Next Page
Loading...
Need help?
General
