Setting Up the MVCI for Updating
Refer to the User Config – Explanations, Set-up, and Customizing Settings to properly set up your MVCI. Make
sure you use the recommended settings under CM Update Mode to avoid problems updating control modules.
Instructions for Updating Control Modules/Units
1. Connect the MVCI to the vehicle’s DLC, and turn the ignition switch to ON (II).
2. Wait for the MVCI to boot up. When the Host Status screen appears, press ENTER.
3. From the User Config menu, select CM Update Mode.
4. From the CM Update Mode menu, select Reprogramming, then press ENTER.
5. The CM Update software information is displayed. Press ENTER to continue.
6. Wait for the MVCI to search for reprogrammable systems. This takes about 90 seconds.
43
To Next Page
Loading...
Need help?
General
