Honeywell H4W2PER2 User Manual

Configuring Network Settings
39
Figure 6-7 UPnP
Enabling UPnP in Windows
The UPnP protocol is used to detect network devices with clients running Windows.
To enable UPnP, select the Enable check box. The camera can now be detected by Windows'
built-in network browser (My Network Places in Windows XP; Network in Windows 7).
To enable UPnP in Windows XP:
1. Go to Start Control Panel  Add or remove programs.
2. Click Add or remove programs, then select Networking Services in the Windows
Components Wizard.
3. Click Details, then select Internet Gateway Device Discovery and Control Client and
UPnP User Interface.
4. Click OK to begin the installation.
To enable UPnP in Windows 7:
1. Go to Start Control Panel Network and Internet  Network and Sharing Center.
2. On the left pane, click Change advanced sharing settings.
3. On your current network profile, in the Network discovery area, click Turn on network
discovery, and then click Save changes.
Configuring SNMP Settings
Go to Setup Network Setup  SNMP.
SNMP (Simple Network Management Protocol) is a protocol for collecting, organizing, and
exchanging management information between managed devices on a network.

Honeywell H4W2PER2 Specifications

General

Brand	Honeywell
Model	H4W2PER2
Category	Security Camera
Language	English