Honeywell H4W2PER2 User Manual

Configuring Storage Settings
63
If you want to erase all the data on the microSD card, click Format. A confirmation message
appears. Click OK to continue. The card is formatted and the camera reboots.
FTP
On the FTP tab, you can enable the FTP storage function. When enabled, event-triggered
video and snapshots (either scheduled or motion detection, depending on what you chose in
Figure 8-3) will be saved to the specified FTP server.
Figure 8-5 FTP
Table 8-2 FTP Configurations
Parameter Function
Enable Select SFTP (Recommended) or FTP.
Server Address Enter the IP address of the FTP server.
Port
The default setting is 21. You can modify this setting as
necessary.
User Name Enter the server user name.
Password Enter the server password.
Remote Directory
Create a name for the directory where recorded video and
snapshots will be stored.
Panic Save
(Local)
Enable Panic Save (Local) to save to the local microSD card when
the network connection to FTP is unavailable.
Note This function is not supported by the following models:
HPW2P1/HBW2PER1.
NAS
On the NAS tab, you can enable network attached storage and configure storage settings.

Honeywell H4W2PER2 Specifications

General

Brand	Honeywell
Model	H4W2PER2
Category	Security Camera
Language	English