HP 100B SFF User Manual

79
Solving USB Flash Drive Problems
If you encounter USB flash drive problems, common causes and solutions are listed in the following
table.
USB flash drive is not seen as a drive letter in Windows.
Cause Solution
The drive letter after the last physical drive is not available.
USB flash drive not found (identified).
Cause Solution
The device is attached to a USB port that has been disabled in
Computer Setup.
The device was not properly seated before power-up.
System will not boot from USB flash drive.
Cause Solution
Boot order is not correct.
The image on the device is not bootable.
The computer boots to DOS after making a bootable flash drive.
Cause Solution
Flash drive is bootable.
Change the default drive letter for the flash drive in Windows.
Run the Computer Setup utility and ensure that the USB ports
are enabled.
Ensure the device is fully inserted into the USB port before
applying power to the system
Run the Computer Setup utility and change boot sequence.
Insert a bootable device.
Install the flash drive only after the operating system boots.

HP 100B SFF Specifications

Operating Environment

operating temperature range	10° to 35°C
nonoperating temperature range	-30° to 60°C
operating relative humidity	10-90%
nonoperating relative humidity	5-95%
operating maximum altitude	3048 m
nonoperating maximum altitude	9144 m

Power

operating voltage range	90-137Vac
rated voltage range	100-127Vac
rated line frequency	50-60Hz
power output	65 W
rated input current	1.6A @ 90 VAC

Weight and Dimensions

height	27 cm
width	10 cm
depth	34.79 cm
weight	4.8 kg