HP 4934A User Manual

Control Commands
Control commands change the 4934A’s operation. Control commands emulate a
front-panel key; sending a command is comparable to pressing the corresponding
key. Another set of commands (query commands) retrieve results from the unit
(see Query Commands, page 7-8).
When the 4934A accepts a command it returns OK to the controller. Unknown
commands cause the unit to return ERR. Inappropriate commands are ignored.
HP 4934A TIMS Remote Control Commands
Command Description
RESET Resets unit to power on condition.
RMT
Puts unit into remote mode, disable front panel.
LCL Returns unit to front-panel (local) control.
TRMT
Same as pressing the TRMT key.
RCV Same as pressing the RCV key.
NORM
Sets input jacks to TRMT-RCV configuration (as with REVERSE key).
REV Sets input jacks to RCV-TRMT configuration (as with REVERSE key),
1135
Sets Tx Impedance to 135 ohms (as with the TRMT key).
T150
Sets Tx Impedance to 150 ohms.
T600 Sets Tx Impedance to 600 ohms.
T900 Sets Tx Impedance to 900 ohms.
T1200 Sets Tx Impedance to 1200 ohms.
R135 Sets Rx Impedance to 135 ohms (as with the RCV key).
R150 Sets Rx Impedance to 150 ohms.
R600 Sets Rx Impedance to 600 ohms.
R900
Sets Rx Impedance to 900 ohms.
R1200 Sets Rx Impedance to 1200 ohms.
Remote Control 7-5

HP 4934A Specifications

General

Brand	HP
Model	4934A
Category	Measuring Instruments
Language	English