HP 4934A User Manual

Range Error Messages
The IXV, FREQ, and THRESH commands accept a range of valid values. If an
out-of-range value is entered, the 4934A still returns OK to the controller. However,
the ERR? can check for the most recent out-of-range command value.
N OT E The ERR? command identifies only the most recent out-of-range value entered.
The ERR? returns one of the following responses.
ERR? Responses
Response
Description
No Errors No range errors were detected since the last ERR? command.
Level over range The last LEV value was too high.
Level under range The last LEV value was too low,
Frequency over range
The last FREQ value was too high.
Frequency under range The last FREQ value was too low.
Threshold over range The last THRESH value was too high.
Threshold under range
The last THRESH value was too low.
Remote Control 7-9

HP 4934A Specifications

General

Brand	HP
Model	4934A
Category	Measuring Instruments
Language	English