HP 8642A Operation And Calibration Manual

Operation
~
Overview
3-24
Model 864 2A/B
CLEAR
The Signal Generator responds identically to Selected Device Clear (SOC) and Device Clear
(DCL) bus commands by clearing any message or uncompleted entries, For example, a
command of FR 1 00 would be cleared because no units terminator has been specified,
Also, with the Clear command, Clear Status Byte occurs, possibly clearing up to 6 status
bits,
The Clear command does not affect instrument settings, However, selecting Instrument
Preset (IP), Partial Preset (PP), or turning the Power from Standby to On, will reset
instrument settings as described in the Detailed Operating Instruction, Instrument Preset,
Pa rtial Preset (page 3 -1 37,)

HP 8642A Specifications

General

Brand	HP
Model	8642A
Category	Inverter
Language	English