Commands
3. Configure the cable of the south IP port of 8P drawer 1 in cabinet 0. Without providing the
destination port, the cabling function finds the matching destination cable according to the
mess configuration. The LEDs of both ports are lit.
MBM> config cables -c1 0 -d1 1 S13 #Turn on LEDs by default
MBM>
4. Configure the cable between IOP3 of 8P drawer 0 on cabinet 1 and IOR0 of PCI drawer 3
on cabinet 4.
MBM> config cables -c1 1 -d1 0 IOP3 -c2 4 -d2 3 IOR0
MBM>
See Also
show cables, test led
3-21
To Next Page
Loading...
Need help?
General