4–10 Reference Guide
Using the Tablet PC Docking Station and Screen Protector
Connecting Standard External Devices
The tablet PC and Docking Station jacks and connectors support
standard external devices.
■ For information about which jack or connector to use, refer
to the documentation included with the device.
■ For information about installing or loading any software
required by the device, refer to the device documentation,
the operating system Help files, or the device manufacturer’s
Web site.
To connect a standard external device to the Docking Station:
1. Turn off the system (tablet PC docked in the Docking
Station).
2. If you are connecting a powered device, turn off the device.
Ä
Do not use the ports or jacks on the tablet PC while it is
docked in the Docking Station. Use the ports and jacks
located on the Docking Station. Failure to use the Docking
Station connectors may result in degraded performance.
You can use the modem jack on the tablet PC while it is
docked, since there is no modem jack on the Docking
Station.
3. Connect the device to a jack or connector on the Docking
Station.
4. If you are connecting a powered device, plug the device
power cord into a grounded electrical outlet.
5. Turn on the device.
6. Turn on the system by pressing the power button on the
tablet PC.
To disconnect a standard external device from the Docking
Station, turn off the device, then disconnect the device from the
Docking Station.
To Next Page
Loading...
Need help?
General
