Discovery tab
Figure 30 Discovery tab (iSCSI)
Click Add to enter target portals that will enable discovery of the device.
Figure 31 Add target portal
You must enter the IP address or fully qualified domain name of the HP StoreOnce Backup System
(for example, myhpd2d.mydomain.com) to add it as a target portal for the host on the Discovery
tab. Do not change the Port; it should be 3260.
Targets tab
This tab contains a list of all available devices.
• If this is the first time that the iSCSI Initiator has been configured and the Installation wizard
has not been run, it will automatically create a library with the appropriate number of target
devices (the default is one loader and one tape drive).
• If target devices have already been configured for the host in the past, they appear in the list;
no more are created.
When you run the iSCSI Initiator manually, new devices have a status of Inactive. You must log on
to the appropriate targets for your host. Remember that each library has at least two devices and
you must log onto each one separately. If the emulation type you have selected allows more drives,
there will be a target device for each drive.
38 Advanced installation
To Next Page
Loading...
Need help?
General