2. Verify that the link partner is configured to run the IEEE 802.3ad
LACP protocol. Make any changes, if necessary, and wait 10
seconds. Then, verify that the link aggregate is enabled.
Verify the ports in the link aggregate by issuing the following
command:
# nwmgr -A all -c lanxxx -S apa
where xxx is the link aggregate instance number (for example, 900).
The Membership column shows the ports that compose the link
aggregate.
If the link aggregate contains ports that you do not want in the
aggregate, delete the ports by issuing the following command:
# nwmgr -d -A links=port-number -c lanxxx
where port-number can be a list of multiple ports numbers separated
by commas and xxx is the instance number of the link aggregate (for
example, 900).
If any ports you wanted in the link aggregate are members of another
link aggregate, delete the ports in the other aggregate by issuing the
following command:
# nwmgr -d -A links=port-number -c aggregate-instance
If there are ports you wanted in the link aggregate that are not members
of the link aggregate, do the following:
Solving HP APA problems 65
To Next Page
Loading...
Need help?
General