3. Activate the new configuration by entering:
# /sbin/init.d/hplm stop
1
# /sbin/init.d/hpapa stop
2
# /sbin/init.d/hpapa start
# /sbin/init.d/hplm start
3
1
If failover groups are also configured.
2
This can interrupt traffic on existing link aggregates.
3
For configuring failover groups.
FEC_AUTO port configuration mode
To configure load balancing and group capability for link aggregate 901 with MAC-based load
balancing, do the following:
1. Edit the /etc/rc.config.d/hp_apaconf file and add the following entries:
HP_APA_INTERFACE_NAME[0]=lan901
HP_APA_LOAD_BALANCE_MODE[0]=LB_MAC
HP_APA_GROUP_CAPABILITY[0]=901
2. Edit the /etc/rc.config.d/hp_apaportconf file and add the following entries to put
lan1 and lan2 into link aggregate 901:
HP_APAPORT_INTERFACE_NAME[0]=lan1
HP_APAPORT_GROUP_CAPABILITY[0]=901
HP_APAPORT_CONFIG_MODE[0]=FEC_AUTO
HP_APAPORT_INTERFACE_NAME[1]=lan2
HP_APAPORT_GROUP_CAPABILITY[1]=901
HP_APAPORT_CONFIG_MODE[1]=FEC_AUTO
3. Activate the new configuration by entering:
# /sbin/init.d/hplm stop
1
# /sbin/init.d/hpapa stop
2
# /sbin/init.d/hpapa start
# /sbin/init.d/hplm start
3
1
If failover groups are also configured.
2
This can interrupt traffic on existing link aggregates.
3
For configuring failover groups.
NOTE: Set the group capability in the previous examples to be the same as that of the link
aggregate to which it belongs. Ports going to different link aggregates should have different
group capabilities.
LACP_AUTO port configuration mode
To configure load balancing and the port key for link aggregate 902 with MAC–based load
balancing, do the following:
1. Edit the /etc/rc.config.d/hp_apaconf file and add the following entries:
HP_APA_INTERFACE_NAME[0]=lan902
HP_APA_LOAD_BALANCE_MODE[0]=LB_MAC
HP_APA_KEY[0]=902
2. Edit the /etc/rc.config.d/hp_apaportconf file and add the following entries to put
lan1 and lan2 into link aggregate 902 and set the APA port key and the configuration
mode:
HP_APAPORT_INTERFACE_NAME[0]=lan1
HP_APAPORT_KEY[0]=902
HP_APAPORT_CONFIG_MODE[0]=LACP_AUTO
HP_APAPORT_INTERFACE_NAME[1]=lan2
98 Configuring HP APA by editing files
To Next Page
Loading...
Need help?
General