Disconnect the tube set
Procedure
1.
Power down the server.
2. Push the female connector (jack) to the male connector (plug) for about 1/8 of an inch.
3.
Rotate the female connector counter-clockwise until the tube is pushed
o the connector by the springs inside.
Remove the server
CAUTION: To avoid accidentally dropping the server, observe the following:
• Always support the bottom of the server when removing and sliding it into the server bay.
• Do not use the release lever as a handle to carry the server.
Procedure
1. Power down the server.
2. Make sure that the server Do not remove LED is
o.
Removal and replacement procedures
27
To Next Page
Loading...
Need help?
General
