HP HPE Apollo 2000 Gen10 Plus User Manual

Specifications
Environmental specifications
Specification Value
Temperature range
1
—
Operating 10°C to 35°C (50°F to 95°F)
Nonoperating –30°C to 60°C (–22°F to 140°F)
Relative humidity (noncondensing)
—
Operating 8% to 90%
28°C (824°F), maximum wet bulb temperature
Nonoperating
5% to 95%
387°C (1017°F), maximum wet bulb temperature
1
All temperature ratings shown are for sea level. An altitude derating of 10°C per 305 m (18°F per 1000 ft) to 3050 m (10000 ft) is
applicable. No direct sunlight allowed. Maximum rate of change is 20°C per hour (36°F per hour). The upper limit and rate of change
might be limited by the type and number of options installed.
For certain approved hardware configurations, the supported system inlet temperature range is extended. The extended
range is 5°C to 10°C (41°F to 50°F) and 35°C to 40°C (95°F to 104°F) at sea level. An altitude derating of 10°C per every
175 m (18°F per every 574 ft) above 900 m (2953 ft) to a maximum of 3050 m (10000 ft) is applicable.
Mechanical specifications
Apollo n2600 Gen10 Plus Chassis
Specifications
Value
Dimensions
—
Height 8750 mm (344 in)
Depth 92400 mm (3638 in)
Width 44000 mm (1732 in)
Weight (approximate maximum values)
—
Empty chassis (chassis without the drives, power supplies, RCM
module, server nodes, and server blanks)
1317 kg (2903 lb)
8 SFF drive configuration 4018 kg (8858 lb)
24 SFF drive configuration 4673 kg (10302 lb)
Specifications 95

HP HPE Apollo 2000 Gen10 Plus Specifications

General

Brand	HP
Model	HPE Apollo 2000 Gen10 Plus
Category	Measuring Instruments
Language	English