To Next Page

To Previous Page

Interconnect bay labelsc3000 interconnect bayc7000 interconnect bayServer blade signal

3 and 45 and 6Mezzanine 2

3 and 47 and 8

3 and 45 and 6Mezzanine 3

3 and 47 and 8

For detailed port mapping information, see the HP BladeSystem enclosure installation poster or

the HP BladeSystem enclosure setup and installation guide for your product on the HP website

(http://www.hp.com/go/bladesystem/documentation).

Installing the server blade into the enclosure

NOTE: When installing additional blades into an enclosure, additional power supplies might

also be needed to meet power requirements. For more information, see the HP BladeSystem

enclosure setup and installation guide for your product on the HP website (http://www.hp.com/

go/bladesystem/documentation).

NOTE: Before installing and initializing the server blade, install any server blade options, such

as an additional processor, hard drive, or mezzanine card.

NOTE: Refer to the HP Integrity BL860c i2, BL870c i2 & BL890c i2 User Service Guide for

information regarding SAS controller configuration.

1. Remove the connector covers if they are present.

2. Prepare the server blade for installation.

Installing and powering on the server blade 37

HP Integrity BL860c i2 Installation Guide

Other manuals for HP Integrity BL860c i2