To Next Page

To Previous Page

Powering on the switch

Verification before power-on

Before powering on the switch, verify that:

 The power cord is properly connected.

 The input power voltage meets the requirement of the switch.

The console cable is properly connected, the terminal or PC used for configuration has started, and the

configuration parameters have been set.

Powering on the switch

Power on the switch, and you can see the following information.

CAUTION:

 If you log in to the switch through the console port after powering on the switch, no boot information is

displayed, and you will enter the command line interface (CLI).

 The output information varies depending on the software version.

Starting......

************************************************************************

* *

* HP A3100-24-PoE v2 EI Switch BOOTROM, Version 109 *

* *

************************************************************************

Creation Date : Apr 12 2011,11:13:54

CPU Clock Speed : 200MHz

Memory Size : 128MB

Flash Size : 16MB

CPLD Version : 003

PCB Version : Ver.A

Mac Address : 000FE23060C1

Press Ctrl-B to enter Extended Boot menu...0

Starting to get the main application file--flash:/a3100 ei.bin!..............

...............................................

The main application file is self-decompressing................................

...............................................................................

......Done!

System is starting...

HP JD320B Installation Guide

Other manuals for HP JD320B