5 Power Requirements
This chapter describes the general power requirements for HP P10000 3PAR Storage Systems.
Powering HP P10000 3PAR Storage Systems
The cabinets used to house the HP P10000 3PAR Storage System components include 4 Power
Distribution Units (PDUs). Each node has 2 dedicated power supplies and each drive chasis has
4 power supplies. Drive cages and controller nodes depend on these power supplies; the drive
chassis power supply is located at the rear of the drive chassis while the node power supply is
located behind the cable management tray in the node chassis. The PDUs are mounted vertically
on the left side at the rear of the cabinet.
Powering HP P10000 3PAR Storage Systems 29
To Next Page
Loading...
Need help?
General