To Next Page

To Previous Page

IPv4 Access Control Lists (ACLs)

Displaying ACL Configuration Data

Display Static Port ACL Assignments

This command briefly lists the identification and type(s) of current static port

ACL assignments to individual switch ports and trunks, as configured in the

running-config file. (The switch allows one static port ACL assignment per

port.)

Syntax: show access-list ports < all | interface >

Lists the current static port ACL assignments for ports and

trunks in the running config file.

Note This information also appears in the show running display. If you execute write

memory after configuring an ACL, it appears in the show config display.

For example, if you assigned a standard ACL with an ACL-ID of “Port-10” to

filter inbound IP traffic on switch ports B10-B11 and trunk trk1, you could

verify these assignments as shown in figure 9-29.

ProCurve(config)# show access-list ports all

Access Lists for Port B10

Inbound : 15

Type : Standard

Access Lists for Port B11

Indicates that a standard ACL

with the ID of “15” is assigned

Inbound : 15

to filter traffic entering the

switch on ports B10 and B11,

and on trunk Trk1.

Type : Standard

Access Lists for Port Trk1

Inbound : 15

Type : Standard

Figure 9-29. Example of Listing the ACL Assignments for Ports and Trunks

9-88

Other manuals for HP PROCURVE 2910AL

Questions and Answers:

Need help?

Do you have a question about the HP PROCURVE 2910AL and is the answer not in the manual?

General