IPv4 Access Control Lists (ACLs)
Displaying ACL Configuration Data
IP Used for Standard ACLs: The source IP address to which the configured mask is applied to determine
whether there is a match with a packet.
Field Description
Src IP Used for Extended ACLs: Same as above.
Dst IP Used for Extended ACLs: The source and destination IP addresses to which the corresponding configured
masks are applied to determine whether there is a match with a packet.
Mask The mask configured in an ACE and applied to the corresponding IP address in the ACE to determine whether
a packet matches the filtering criteria.
Proto Used only in extended ACLs to specify the packet protocol type to filter. Must be either IP, TCP, or UDP. For
TCP protocol selections, includes the established option, if configured.
Port(s) Used only in extended ACLs to show any TCP or UDP operator and port number(s) included in the ACE.
TOS Used only in extended ACLs to indicate Type-of-Service setting, if any.
Precedence Used only in extended ACLs to indicate the IP precedence setting, if any.
Display All ACLs and Their Assignments in the Routing
Switch Startup-Config File and Running-Config File
The show config and show running commands include in their listings any
configured ACLs. Refer to figure 9-9 (page 9-39) for an example. Remember
that show config lists the startup-config file and show running lists the running-
config file.
9-91
To Next Page
Need help?
General
