HP ProDesk 400 G2 Small Form Factor User Manual

Removing a 2.5-inch hard drive
1. Prepare the computer for disassembly (Preparation for disassembly on page 19).
2. Remove the access panel (
Access panel on page 20).
3. Rotate the drive cage to its upright position.
4. Disconnect the power cable and data cable from the back of the hard drive.
5. Pull outward on the release lever at the rear of the drive (1) then slide the drive back until it stops and
pull it down and out of the drive bay (2).
Installing a 2.5-inch hard drive
1. Prepare the computer for disassembly (Preparation for disassembly on page 19).
2. If the computer is on a stand, remove the computer from the stand.
3. Remove the access panel (
Access panel on page 20).
Drives 43

HP ProDesk 400 G2 Small Form Factor Specifications

General

Brand	HP
Model	ProDesk 400 G2 Small Form Factor
Category	Desktop
Language	English