HP ProDesk 400 G2 Small Form Factor User Manual

Speaker
The speaker is attached to the front of the chassis under the rotating drive cage.
1. Prepare the computer for disassembly (
Preparation for disassembly on page 19).
2. Remove the access panel (
Access panel on page 20).
3. Remove the front bezel (
Front bezel on page 21).
4. Rotate the drive cage to its upright position.
5. Lift the metal clip (1) that secures the speaker cable, and then disconnect the speaker wire from the
white system board connector labeled SPKR (2).
6. From the outside, front of the chassis, remove the two Torx screws that secure the speaker to the
chassis.
Speaker 53

HP ProDesk 400 G2 Small Form Factor Specifications

General

Brand	HP
Model	ProDesk 400 G2 Small Form Factor
Category	Desktop
Language	English