HP ProDesk 400 G2 Small Form Factor User Manual

Removing a slim optical drive
CAUTION: All removable media should be taken out of a drive before removing the drive from the
computer.
1. Prepare the computer for disassembly (Preparation for disassembly on page 19).
2. Remove the access panel (
Access panel on page 20).
3. Disconnect the power and data cables (1) from the rear of the optical drive, push the green release latch
on the right rear side of the drive toward the center of the drive (2), then slide the drive forward and out
of the bay through the front bezel (3).
CAUTION: When removing the cables, pull the tab or connector instead of the cable itself to avoid
damaging the cable.
38 Chapter 4 Removal and replacement procedures: Small Form Factor

HP ProDesk 400 G2 Small Form Factor Specifications

General

Brand	HP
Model	ProDesk 400 G2 Small Form Factor
Category	Desktop
Language	English