EasyManuals Logo

HP ProDesk 600 G1 Tower User Manual

HP ProDesk 600 G1 Tower
243 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #146 background imageLoading...
Page #146 background image
Computer Setup—Security
NOTE: Support for specific Computer Setup options may vary depending on the hardware
configuration.
Table 7-3 Computer Setup—Security
Option Description
Setup Password Allows you to set and enable a setup (administrator) password.
NOTE: If the setup password is set, it is required to change Computer Setup options, flash the
ROM, and make changes to certain plug and play settings under Windows.
Power-On
Password
Allows you to set and enable a power-on password. The power-on password prompt appears after
a power cycle or reboot. If the user does not enter the correct power-on password, the unit will not
boot.
Password Options
(This selection appears
only if a power-on
password or setup
password is set.)
Allows you to enable/disable:
Lock Legacy Resources (determines whether or not Windows Device Manager is allowed to
change resource settings for serial and parallel ports).
Stringent security (enabling the stringent password disables the ability to reset the password by
moving the jumper on the system board). Default is disabled.
CAUTION: If you enable the stringent security feature and you forget the setup password or
the power-on password, the computer is inaccessible and can no longer be used.
If you lose or forget the password, the system board must be replaced. This scenario is not
covered under warranty.
To prevent the computer from becoming permanently unusable, record your configured setup
password or power-on password in a safe place away from your computer. Without these
passwords, the computer cannot be unlocked.
Setup Browse Mode (appears if a setup password is set) (allows viewing, but not changing,
the F10 Setup Options without entering setup password). Default is enabled.
Password prompt on F9 & F12 (requires setup password to use these boot functions). Default is
enabled.
Network Server Mode. Default is disabled.
Smart Cover Allows you to:
Lock/unlock the Cover Lock.
Set the Cover Removal Sensor to Disable/Notify User/Setup Password.
NOTE: Notify User alerts the user that the sensor has detected that the cover has been removed.
Setup Password requires that the setup password be entered to boot the computer if the sensor
detects that the cover has been removed.
136 Chapter 7 Computer Setup (F10) Utility

Table of Contents

Other manuals for HP ProDesk 600 G1 Tower

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the HP ProDesk 600 G1 Tower and is the answer not in the manual?

HP ProDesk 600 G1 Tower Specifications

General IconGeneral
Tcase72 °C
Bus typeDMI2
SteppingC0
FSB ParityNo
Processor cache3 MB
Processor cores2
Processor modeli3-4130
System bus rate5 GT/s
Processor familyIntel® Core™ i3
Processor seriesIntel Core i3-4100 Desktop series
Processor socketLGA 1150 (Socket H3)
Processor threads4
Processor codenameHaswell
Number of QPI links0
Processor frequency3.4 GHz
Processor cache typeSmart Cache
Processor lithography22 nm
Processor manufacturerIntel
Processor front side bus- MHz
PCI Express slots version3.0
Processor operating modes64-bit
ECC supported by processorYes
PCI Express configurations1x8, 1x16, 2x4, 2x8
Thermal Design Power (TDP)65, 54 W
Number of processors installed1
Maximum number of PCI Express lanes16
Memory types supported by processorDDR3-1333/1600, DDR3L-1333/1600 @ 1.5V
Memory clock speeds supported by processor1333, 1600 MHz
Memory bandwidth supported by processor (max)25.6 GB/s
Maximum internal memory supported by processor32 GB
Memory slots4x DIMM
Internal memory4 GB
Memory channelsDual-channel
Memory clock speed1600 MHz
Internal memory typeDDR3-SDRAM
Memory layout (slots x size)1 x 4 GB
HDD speed7200 RPM
HDD interfaceSATA
Storage mediaHDD
Optical drive typeDVD Super Multi
Total storage capacity500 GB
Intel segment taggingEnterprise, Small Business
On-board graphics card ID0x41E
Discrete graphics card modelNot available
On-board graphics card modelIntel® HD Graphics 4400
On-board graphics card familyIntel® HD Graphics
Maximum on-board graphics card memory1.74 GB
On-board graphics card base frequency350 MHz
On-board graphics card DirectX version11.1
On-board graphics card dynamic frequency (max)1150 MHz
Number of displays supported (on-board graphics)3
Recovery operating systemWindows 8 Pro
Operating system installedWindows 7 Professional
Cabling technology10/100/1000Base-T(X)
Ethernet LAN data rates10, 100, 1000 Mbit/s
USB 2.0 ports quantity6
Chassis typeMicro Tower
Product colorBlack
Country of originChina
Audio systemHD
Product typePC
Motherboard chipsetIntel® Q85
Scalability1S
Processor ARK ID77480
Processor package size37.5 x 37.5 mm
Supported instruction setsAVX 2.0
Thermal solution specificationPCG 2013C
Intel Small Business Advantage (SBA) version1.00
Intel® Small Business Advantage (Intel® SBA)-
Intel Stable Image Platform Program (SIPP) version0.00
Power supply320 W
Operating temperature (T-T)10 - 35 °C
Operating relative humidity (H-H)10 - 90 %
Weight and Dimensions IconWeight and Dimensions
Depth442 mm
Width170 mm
Height399 mm
Weight9300 g

Related product manuals