Figure 37 Advanced Identifiers page
Figure 38 Add/Edit Identifier page
8. Click Next.
9. Click Finish to complete the wizard and create the iSCSI Target.
Create Virtual Disk Wizard
This section describes how to create an iSCSI Virtual Disk using the Create Virtual Disk Wizard.
NOTE:
In order to create iSCSI Virtual Disks, it is required that physical disks are formatted as NTFS.
1. In the Microsoft iSCSI Software Target MMC snap-in, click the Devices node.
2. On the details view (right pane) of the Devices node, right-click a volume and select Create Virtual
Disk.
3. Click Next on the Welcome page of the wizard.
4. On the File page, specify the full path to use as the virtual disk and click Next.
5. On the Size page, specify the size to use for the virtual disk and click Next. If the file already
exists, you cannot specify a new size.
Enterprise storage servers124
To Next Page
Loading...
Need help?
General
