104 Fabric OS Troubleshooting and Diagnostics Guide
53-1002150-02
Syslogd configuration
10
local7.info /var/adm/swinfo
local7.debug /var/adm/debug7
If you prefer to map Fabric OS severities to a different UNIX local7 facility level, see “Setting the
facility level” on page 104.
Configuring the switch
Configuring the switch involves specifying syslogd hosts and, optionally, setting the facility level.
You can also remove a host from the list of syslogd hosts.
Specifying syslogd hosts
1. Connect to the switch and log in as admin.
2. Enter the syslogdIpAdd command and specify an IP address.
3. Verify that the IP address was entered correctly, using the syslogdIpShow command.
The syslogdIpadd command accepts IPv4 and IPv6 addresses. You can specify up to six host IP
addresses for storing syslog messages, as shown in this example:
switch:admin> syslogdipadd 1080::8:800:200C:417A
switch:admin> syslogdipadd 1081::8:800:200C:417A
switch:admin> syslogdipadd 1082::8:800:200C:417A
switch:admin> syslogdipadd 10.1.2.4
switch:admin> syslogdipadd 10.1.2.5
switch:admin> syslogdipadd 10.1.2.6
switch:admin> syslogdipshow
syslog.IP.address.1080::8:800:200C:417A
syslog.IP.address.1081::8:800:200C:417A
syslog.IP.address.1082::8:800:200C:417A
syslog.IP.address.4 10.1.2.4
syslog.IP.address.5 10.1.2.5
syslog.IP.address.6 10.1.2.6
Setting the facility level
1. Connect to the switch and log in as admin.
2. Enter the following command:
switch:admin> syslogdfacility -l n
n is a number from 0 through 7, indicating a UNIX local7 facility. The default is 7.
It is necessary to set the facility level only if you specified a facility other than local7 in the host
/etc/syslog.conf file.
Removing a syslogd host from the list
1. Connect to the switch and log in as admin.
2. Enter the syslogdIpRemove command:
switch:admin> syslogdipremove 10.1.2.1
To Next Page
Loading...
Need help?
General