Copying to a single workstation
CAUTION A setup configuration is model-specific. File system corruption can result if the
source and target workstations are not the same model. For example, do not copy the setup
configuration from an HP xw6200 Workstation to an HP xw9400 Workstation.
1. Select a setup configuration to copy, then shut down the workstation.
2. Reboot the workstation.
3. As soon as the screen illuminates, press and hold the F10 key until you enter the Computer Setup
Utility. Press Enter to bypass the title screen, if necessary.
NOTE If you do not press the F10 key at the appropriate time, you must restart the
workstation and press and hold the F10 key again to access the utility.
If you are using a PS/2 keyboard, disregard the keyboard error message that might appear.
4. Insert the configuration diskette or USB.
5. Click File>Replicated Setup>Save to Removable Media. Follow the instructions on the screen
to create the configuration diskette or USB.
6. Power off the workstation to be configured and insert the diskette or USB.
7. Power on the workstation to be configured.
8. As soon as the screen illuminates, press and hold the F10 key until you enter the Computer Setup
Utility. Press Enter to bypass the title screen, if necessary.
9. Click File>Replicated Setup>Restore from Removable Media, and follow the instructions on the
screen.
10. Restart the workstation when the configuration is complete.
Copying to multiple workstations
CAUTION A setup configuration is model-specific. File system corruption can result if the
source and target workstations are not the same model. For example, do not copy the setup
configuration from an HP xw6200 Workstation to an HP xw9400 Workstation.
This method takes a little longer to prepare the configuration diskette or USB, but copying the
configuration to target workstations is significantly faster.
NOTE A bootable diskette or USB is required for this procedure. If Windows XP is not available
to create a bootable diskette or USB, use the method for copying to a single workstation instead
(see
Copying to a single workstation on page 39).
1. Create a bootable diskette or USB.
2. Select a setup configuration to copy, then shut down the workstation.
3. Power on the workstation.
4. As soon as the screen illuminates, press and hold the F10 key until you enter the Computer Setup
Utility. Press Enter to bypass the title screen, if necessary.
ENWW Desktop management 39
To Next Page
Loading...
Need help?
General