Installing a hard drive
1. Select a drive bay in which to install the drive. If installing more than one hard drive, use the hard
drive order shown in the following image.
Figure 4-39 Identifying hard drive installation order
2. Squeeze the green tabs, and slide the rails out of the empty bay.
3. Attach the rails to the hard drive. Align the pins on the rails with the hard drive holes, and snap the
rails into place.
Figure 4-40 Attaching rails to the hard drive
4. Push the drive into the selected bay until it snaps into place.
88 Chapter 4 Removal and replacement procedures ENWW
To Next Page
Loading...
Need help?
General