3. Remove the PCI slot cover (2).
4. Lower the PCI (3) or PCI Express (3) card into the chassis. Verify that the keyed components of
the card align with the socket.
If installing a card with an auxiliary power connector, plug in the power supply cable or adapter
cable supplied with the card (4).
5. Ensure that all cards are properly seated, and close the PCI retention clamp.
Figure 4-25 Installing PCI or PCIe card
Front fan removal
To remove the front fan:
1. Disconnect power from the system (
Pre-disassembly procedures on page 55), and remove the
access panel (
Access panel on page 61). Place the workstation on its side with the system board
facing up.
2. Disconnect optical and floppy drive cables from the system board. Remove full length PCI cards.
3. Disconnect the front fan cable from the connector on the system board.
78 Chapter 4 Removal and replacement procedures ENWW
To Next Page
Loading...
Need help?
General