4 Setting up, backing up, restoring, and
recovering Windows 10
Activating and customizing the software
Additional information is available in online help after you activate the operating system.
CAUTION: Be sure there is a 10.2 cm (4 inch) clearance at the back of the unit and above the monitor to
permit the required airow.
Initial Windows operating system setup
The rst time you turn on the workstation, the operating system is set up and activated automatically. This
process takes about 5 to 10 minutes. Carefully read and follow the instructions on the screen to complete the
initial Windows setup.
We recommend that you register your workstation with HP during operating system set up so you can receive
important software updates, facilitate support questions, and sign up for special oers.
CAUTION: After the setup process has begun, DO NOT TURN OFF THE WORKSTATION UNTIL THE PROCESS IS
COMPLETE. Turning o the workstation during the setup process may damage the software that runs the
workstation or prevent its proper installation.
Customizing the monitor display
If you wish, you can select or change the monitor refresh rates, screen resolution, color settings, font sizes,
and power management settings.
For more information, refer to the online documentation provided with the graphics controller utility or the
documentation that came with your monitor.
▲
Right-click on the Windows desktop, then click Personalize or Screen resolution to change display
settings.
– or –
Click the Start icon, click Settings, and the click Personalization.
Turning o the workstation
To properly turn o the workstation, shut down the operating system software.
▲
Click the Start icon, click the Power icon, and then select Shut down.
– or –
From the taskbar, type settings, select Settings, type shut, and then click Turn o your PC.
Activating and customizing the software 15
To Next Page
Loading...
Need help?
General
