AP7052DN&AP7152DN
Hardware Installation and Maintenance Guide
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
The AP supports the following power supply modes: PoE power supply and DC power supply.
When the AP uses the DC power supply, use a power adapter for power supply; otherwise, the AP
may be damaged.
For power adapter models, see 5.9 Power Adaptation Solution.
1.2 Indicator Description
The AP7052DN and AP7152DN provide only a single indicator, as shown in Figure 1-1.
The indicator is located inside the panel, which turns on after the AP is powered on.
Indicator colors may vary slightly at different temperature.
Figure 1-1 Indicator
Table 1-3 Description about the single indicator
Default
status
after
power-on
The AP is just powered on and the software is not
started yet.
Steady on
after
blinking
once
After the system is reset and starts uploading the
software, the indicator blinks green once. Until the
software is uploaded and started, the indicator
remains steady green.
Blinking
once
every 2s
(0.5 Hz)
The system is running properly, the Ethernet
connection is normal, and STAs are associated
with the AP.
The system enters the Uboot CLI.
The system is running properly, the Ethernet
To Next Page
Loading...
Need help?
General
