AP7052DN&AP7152DN
Hardware Installation and Maintenance Guide
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
----End
5.1.3.8 Common Network Cable Faults and Preventive Measures
Table 5-12 lists common network cable faults and preventive measures.
Table 5-12 Common network cable faults and preventive measures
The device cannot be
powered using PoE.
The device restarts
frequently.
A large number of error
packets exist on the
device or services are
interrupted.
A network cable has high
resistance or is too long.
Before using network cables
purchased from other
suppliers, use a multimeter
or other tools to measure
cable resistance. If the
resistance of a network
cable does not comply with
the quality requirement of
the PoE standard, as shown
in Table 5-13, replace the
network cable.
Non-standard network cable
connectors cause poor
contact with device
interfaces.
Before making a network
cable, use a standard go-no
go gauge to test the
connectors purchased from
other suppliers. Replace the
connectors if they do not
comply with the standard.
Wires in a network cable are
connected to wrong pins.
After a network cable is
made, use a conduction
tester to measure cable
connectivity. For test
details, see 5.1.3.7 Testing
the Connection of
Assembled Cables.
A network cable connector
is not crimped securely,
causing poor contact
between the network cable
and pins in the connector.
When testing a network
cable with a conduction
tester, gently shake the cable
connector and check
whether indicators on the
conduction tester are in
normal state. If indicators 1
to G turn on in a wrong
sequence, remake the
network cable.
The following methods are often used to test network cable resistance, and the test criteria are
listed in Table 5-13:
Use a network cable tester (high-end cable tester of Fluke) to measure network cable
resistance.
To Next Page
Loading...
Need help?
General
