4 Installation
4.1 Installation Modes
The SUN2000 can be installed on a support or pole clamp.
Table 4-1 Installation modes
Installation
Mode
Screw Specications Description
Support
mounting
M12x40 bolt assembly Delivered with
the product
Pole-clamp
mounting
Depending on the pole clamp Prepared by the
customer
4.2 Installation Requirements
4.2.1 Site Selection Requirements
Installation Environment Requirements
● Do not install the inverter in working or living areas.
● Do not install the inverter in noise-sensitive areas, such as residential areas,
oce areas, and schools.
● If the inverter is installed in public places (such as parking lots, stations, and
factories) other than working and living areas, install a protective net outside
the device and set up a safety warning sign to isolate the device. This is to
avoid personal injury or property loss caused by accidental contact by non-
professionals or other reasons during device operation.
● If the inverter is installed in a place with abundant vegetation, in addition to
routine weeding, harden the ground underneath the inverter using cement or
gravel (recommended area: 3 m x 2.5 m).
SUN2000-(250KTL, 280KTL, 300KTL, 330KTL) Series
User Manual 4 Installation
Issue 07 (2023-06-30) Copyright © Huawei Technologies Co., Ltd. 27
To Next Page
Loading...
Need help?
General