English - 33
2. SPECIAL MENU FUNCTIONS
Operating data (5-1-1)
This part menu contains information about:
• Key data
• Search times
Key data
• Total running (h) =
Total running is defined as the accumulated time
in hours that the wheel motors have run. This
means the time when the Automower
®
runs
without mowing is also included in the running
time. The time stated here is the time stated in
the main menu.
• Run time/fault (h) =
an average time of how many hours the
Automower
®
has run for each fault message
displayed. Run time/fault is the total running time
divided by the number of occurring faults.
• Docking efficiency (%) =
a measurement of on how many occasions when
the Automower
®
has reached the N-field this has
resulted in a successful docking.
Docking efficiency should be as high as possible.
Normally the value for docking efficiency is about
90 % or higher.
• Searching (%) =
a measurement of how much of the total running
time that the Automower
®
has searched after the
charging station.
The value for searching varies depending on the
size of the working area and the design of the
installation. You should aim for the lowest possible
searching value. Depending on the installation, it
is normal for the mower to search between
10 – 20 %.
• Efficiency (%) =
a measurement of how much of the total operating
time that the Automower
®
has mown the lawn.
Efficiency is the mowing time divided by the
charging time+running time.
• Time/charge (min) =
an average time for how long each charging
period has taken.
Operating data
Trip Op. counters
Fault messages
Software
Battery history
5-1-1
Key data
Search times
Total running
Run time/fault
Docking efficency
Searching
Efficiency
Time/charge
Key data
Search times
To Next Page
Loading...
Need help?
General
