52 - English
3. INSTALLATION
3.5 Problems following OUT
Tip! If Automower
®
finds it difficult to follow the
guide wire out from the charging station, the
guide wire should, if possible, be routed further
out from the front edge of the charging plate.
Should this not be possible, reduce the reversing
length or set a lower Corridor width value.
If the mower has difficulty in finding or starting to
follow the boundary loop out from the charging
station, the Corridor width setting should be
increased. The Reversing distance setting may need
slight adjustment. The Reverse distance setting can
be found in the Exit anglesmenu.
3.6 One Automower
®
in several
gardens
Automower
®
can be connected/coded for more than
one installation, which allows a mower to be used in
several gardens.
As usual the mower is coded to the first garden and
then to the next garden via the PIN code function (The
function to change the PIN code). Different PIN-codes
should be used if the installations are positioned closer
than 4 m (13 ft).
3.7 Several Automower
®
machines
in one garden
If the lawn in the garden is larger than that
recommended for the chosen Automower
®
, two or
more mowers and charging stations should be installed
in the garden.
Set up the installation, each with their own working
area, with approximately 10 cm (4”)distance from
each other. All the grass in the garden will then be
cut.
The installations will require different PIN codes.
IMPORTANT INFORMATION
If Automower
®
does not find the right
strength on the loop signal when it leaves the
charging station, it will start to mow
immediately instead.
To Next Page
Loading...
Need help?
General
