Learn your Quilt Designer II
15
1. 2.
Presser foot S
This foot is used for side-motion stitches.
Sensor Buttonhole Foot
When connected to the machine it measures
but ton hole length and sews the buttonhole size that
has been entered into the machine. The mid dle mark
gives a 9/16'' (15 mm) buttoning edge.
Changing the Presser Foot
Turn off the main switch.
1. Make sure that the needle is in the highest
po si tion. Pull the presser foot towards you.
2. Line up the cross pin on the foot between the
spring and the presser foot ankle. Press back until
the foot snaps into place.
S
To Next Page
Loading...
Need help?
General
