Safety and compliance SC-25
Symbols and marks
Correct direction of motor rotation (motor rotation arrow)
S/N
Serial number
V
Volts
Φ
Number of phases in a power system
Hz
Frequency (hertz)
FLA
Full-load current (amperage)
SCCR
Short-circuit current rating
OIL
Type of hydraulic fluid recommended
OIL VOL
Hydraulic fluid tank volume (liters)
Imax
Primary motor maximum current draw (amperes)
kW
Primary motor power output (kilowatts)
l/min
Maximum outlet flow rate (liters/minute)
MPa
Maximum outlet water pressure (megapascals)
Kg
Weight (kilograms)
IP
Ingress protection rating
P/N
Part number
The Conformité Européene (CE) mark affixed to a product signifies the manufacturer’s declaration
of conformity to applicable European directives and standards.
Only those versions of Hypertherm products with a CE mark on or near the data plate have been
tested for compliance with the applicable European directives, such as the Low Voltage Directive,
the Electromagnetic Compatibility Directive, and the Machinery Directive.
Identifies the terminal of a protective earth (ground) electrode or a terminal intended to connect to
an external conductor for protection against electric shock during a fault condition.
Controls on
Remote key switch off
Remote key switch on
Prefilter water pressure
Postfilter water pressure
C
OMPRESSED AIR IN
Compressed air that operates the bleed-down valve
C
UTTING WATER IN
Low-pressure water from a water softener, a reverse osmosis system, a well, or a public utility
C
UTTING WATER OUT
Water that has been pressurized by the intensifier for piercing or cutting
W
ASTE WATER OUT
Water from the bleed-down valve and the low-pressure system to a drain
To Next Page
Loading...
Need help?
General
