Hypertherm MAX200 User Manual

4-26 MAX200 Instruction Manual
14
OPERATION
PAC200T/PAC200E Hand Torch
Stainless Steel
100 amps
•
Air Plasma / Air Shield
This gas combination gives good cut speed, low dross levels and is very economical. Some surface
nitriding and surface oxidation of alloying elements can occur.
Piercing above 3/8 inch (10 mm) not recommended.
* If leads are greater than 50 feet, increase TEST pressure 5 psi for every extra 50 feet of torch lead length.
020919
Shield
020611
Nozzle
020915
Retaining cap
120547
Electrode
020607
Swirl ring
Plasma
Gas
Type
Plasma Gas
Pressure
TEST/RUN
Shield
Gas
Type
Shield
Gas
Pressure
Arc
Current
Setting
Arc
Voltage
Setting
Approx.
Motion
Delay Time
Plasma
Gas Inlet
Pressure
Shield
Gas Inlet
Pressure
(Inches) (mm) (psi) (psi) (Inches) (mm) (amps) (volts) (ipm) (mm/min) (sec) (psi) (psi)
1/8 3 Air 22-26* / 54-58 Air 60 5/64 2 100 125 140 3560 90 90
3/16 5 1/8 3 130 110 2800 0.5
1/4 6 1/8 3 130 80 2030 0.5
3/8 10 1/8 3 135 55 1400 0.5
1/2 12 1/8 3 140 35 890
5/8 15 .157 4 145 25 635
3/4 20 3/16 5 150 20 510
Material
Thickness
Torch-to-work
Distance
Travel Speed
(37 SCFH) (270 SCFH)

Hypertherm MAX200 Specifications

General

Brand	Hypertherm
Model	MAX200
Category	Welding System
Language	English