Hypertherm MAX200 User Manual

MAX200 Instruction Manual 4-27
15
OPERATION
PAC200T/PAC200E Hand Torch
Stainless Steel
40 amps
•
Air Plasma / Air Shield
This gas combination gives good cut speed, low dross levels and is very economical. Some surface
nitriding and surface oxidation of alloying elements can occur.
Piercing above 1/8 inch (3 mm) not recommended.
* If leads are greater than 50 feet, increase TEST pressure 5 psi for every extra 50 feet of torch lead length.
Plasma
Gas
Type
Plasma Gas
Pressure
TEST/RUN
Shield
Gas
Type
Shield
Gas
Pressure
Arc
Current
Setting
Arc
Voltage
Setting
Approx.
Motion
Delay Time
Plasma
Gas Inlet
Pressure
Shield
Gas Inlet
Pressure
(Inches) (mm) (psi) (psi) (Inches) (mm) (amps) (volts) (ipm) (mm/min) (sec) (psi) (psi)
.0156 (28 GA.) Air 16-20* / 56-60 Air 60 5/64 2 40 110 280 7100 90 90
.0188 (26 GA.) 5/64 2 110 240 6100
.025 (24 GA.) 5/64 2 115 220 5550
1/32 5/64 2 115 200 5050 0.5
.050 (18 GA.) 5/64 2 120 145 3700 0.5
1/16 1.5 5/64 2 120 120 3050 1.0
1/8 3 5/64 2 125 75 1900 1.5
1/4 6 1/8 3 135 30 750
3/8 10 1/8 3 140 12 300
Material
Thickness
Torch-to-work
Distance
Travel Speed
(25 SCFH) (275 SCFH)
020917
Shield
020689
Nozzle
020915
Retaining cap
220021
Electrode
020613
Swirl ring

Hypertherm MAX200 Specifications

General

Brand	Hypertherm
Model	MAX200
Category	Welding System
Language	English