Hypertherm MAX200 User Manual

MAX200 Instruction Manual 4-31
9-99
OPERATION
Piercing above 3/8 inch (10 mm) not recommended.
* If leads are greater than 50 feet, increase TEST pressure 5 psi for every extra 50 feet of torch lead length.
PAC200T/PAC200E Hand Torch
Stainless Steel
100 amps
•
H35 Plasma / N
2
Shield
This gas combination gives good cut speed, low dross levels and is very economical. Some surface
nitriding and surface oxidation of alloying elements can occur.
Plasma
Gas
Type
Plasma Gas
Pressure
TEST/RUN
Shield
Gas
Type
Shield
Gas
Pressure
Arc
Current
Setting
Arc
Voltage
Setting
Approx.
Motion
Delay Time
Plasma
Gas Inlet
Pressure
Shield
Gas Inlet
Pressure
(Inches) (mm) (psi) (psi) (Inches) (mm) (amps) (volts) (ipm) (mm/min) (sec) (psi) (psi)
1/8 3 H35 32-36*/ 56-60
N
2
60 5/64 2 100 130 50 1260 120 90
3/16 5 1/8 3 135 40 1060 0.5
1/4 6 1/8 3 140 35 890 0.5
3/8 10 1/8 3 140 30 750 0.5
1/2 13 1/8 3 145 25 630
Material
Thickness
Torch-to-work
Distance
Travel Speed
(20 SCFH) (270 SCFH)
020919
Shield
020611
Nozzle
020915
Retaining cap
020415
Electrode
020607
Swirl ring

Hypertherm MAX200 Specifications

General

Brand	Hypertherm
Model	MAX200
Category	Welding System
Language	English