SETUP
powermax1650 Operator Manual 3-11
3
T100M-2 torch alignment
Mount the machine torch perpendicular to the workpiece in
order to get a vertical cut. Use a square to align the torch at 0°
and 90°.
Gas supply installation
Connect the air hose as follows:
1. Air fitting
• For the standard model: Install a 1/4
NPT gas fitting on to the air filter inlet.
The CE model provides a G1/4
adapter in the CE kit. Use liquid pipe
sealant on the threads.
• Nipple/Adapter is found in the
consumables box, located on the side
of the power supply cover.
2. Air hose
• Use an inert gas hose with a 3/8 inch
(9.5 mm) internal diameter. Connect
it to the gas fitting installed in step 1.
Adjust the air pressure according to the
procedure in Section 4, Operation.
Torch
CAUTION: Never use PTFE tape when
installing the nipple or adapters. Bits of
tape can break off and enter the air line
and harm the pressure regulator,
pressure switch, and valve.
0°
90°
To Next Page
Loading...
Need help?
General
