Hypertherm powermax1650 User Manual

SETUP
3-14 powermax1650 Operator Manual
2
4. Find the power board. Use insulated type 1/4-inch faston terminal ends to connect to J15 and
J16.
Signal: Arc voltage (torch height control)
Type: Output
Notes: Full arc voltage. No voltage divider. 300 VDC
maximum. (Signal not available on rear panel
connector.)
J15 +VDC
J16 –VDC
5. Tighten the strain relief.
6. Replace the cover

Hypertherm powermax1650 Specifications

General

Brand	Hypertherm
Model	powermax1650
Category	Welding System
Language	English