7-49
2
1
Remove (-) lead first
Pos(+)
Neg(-)
10. REPLACEMENT AND CHECK
10. REPLACEMENT AND CHECK
13036MI29
160D7EOM65
36070FW05
Removing and installing
Remove the lead from the ground side
(Normally the (-) terminal side) of the battery. It
is dangerous to let a tool, etc., touch the (+)
terminal and the body at the same time, since
this causes a spark.
WIRING, GAUGES
Check regularly and repair loose or malfunctioning
gauges when found.
1)
BATTERY
Clean
Wash the terminal with hot water if it is
contaminated, and apply grease to the
terminals after washing.
Battery gas can explode. Keep sparks and
flames away from batteries.
Always wear protective glasses when working
with batteries.
Do not stain clothes or skin with electrolyte as it
is acid.
Be careful not to get the electrolyte in eyes.
Wash with clean water and go to the doctor if it
enters the eyes.
(1)
①
2)
Recycle
Never discard a battery.
Always return used batteries to one of the
following locations.
·A battery supplier
·An authorized battery collection facility
·Recycling facility
(2)
(3)
①
When remounting, connect the ground
connection last
Do not allow tools to touch the (+) terminal and
Do not allow tools to touch the (+) terminal and
the body of the truck at the same time. This can
the body of the truck at the same time. This can
cause sparking and explosion.
cause sparking and explosion.
When reinstalling the cables after replaced the
When reinstalling the cables after replaced the
battery, pay close attention to maintaining the
battery, pay close attention to maintaining the
same alignment state of the cables as it was
same alignment state of the cables as it was
when supplied. Otherwise, the machine can be
when supplied. Otherwise, the machine can be
exposed to the fire hazards.
exposed to the fire hazards.
②
To Next Page
Loading...
Need help?
General
