FEATURES OF YOUR HYUNDAI
1- 29
B260C02Y-GAT
Traction Control Indicator
Lights(If installed)
The traction control indicators change opera-
tions according to the ignition switch position
and whether the system is in operation or not.
They will illuminate when the ignition key is
turned to the "ON" position, but should go out
after three seconds. If the TCS-OFF indicator
blinks or stays on, take your car to your autho-
rized Hyundai dealer and have the system
checked. See section 2 for more information
about the TCS system.
B260Q02Y-AAT
Cruise Indicator (If installed)
The cruise indicator light in the instrument clus-
ter is illuminated only when the vehicle cruising
speed has been set using the control switch.
The indicator light does not illuminate when the
main cruise control switch is activated.
Information about the use of cruise control
begins on page 1-43.
firmly. Excessive rotor damage will result if the
worn pads are not replaced. See your Hyundai
dealer immediately.
B280A01A-AAT
FUEL GAUGE
B280A01Y
B290A01A-AAT
ENGINE COOLANT TEMPERATURE
GAUGE
B290A01Y
WARNING:
Never remove the radiator cap when the
engine is hot. The engine coolant is under
pressure and could erupt and cause severe
burns. Wait until the engine is cool before
adding coolant to the reservoir.
The needle on the engine coolant temperature
gauge should stay in the normal range. If it
moves across the dial to "H" (Hot), pull over
and stop as soon as possible and turn off the
engine. Then open the hood and check the
coolant reservoir level and the water pump
drive belt. If you suspect cooling system trou-
ble, have your cooling system checked by a
Hyundai dealer as soon as possible.
The needle on the gauge indicates the approx-
imate fuel level in the fuel tank. The fuel capac-
ity is given in Section 9.
B900A01A-AAT
ACOUSTIC WARNING SOUND
(If installed)
The acoustic warning chime sounds when the
tail lights are on and the door in driver side is
open. This prevents the battery from discharg-
ing when the car is left with the tail lights on.
The chime sounds until the tail lights are turned
off.
B270A01A-AAT
BRAKE PAD WEAR WARNING
SOUND
The front disc brake pads have wear indicators
that should make a high-pitched squealing or
scraping noise when new pads are needed.
The sound may come and go or be heard all the
time when the vehicle is moving. It may also be
heard when the brake pedal is pushed down
To Next Page
Loading...
Need help?
General
