FEATURES OF YOUR HYUNDAI
1- 44
B660B01Y-AAT
To Set the Cruise Speed
B660B01Y
1. Push in the cruise control main switch. This
turns the system on.
2. Accelerate to desired cruising speed above
25 mph (40 km/h).
3. Push the control switch to "SET" (COAST)
position and release it. The "CRUISE" indi-
cator light in the instrument cluster will illu-
minate after you have set the vehicle speed
at the desired speed.
4. Remove your foot from the accelerator ped-
al and the desired speed will automatically
be maintained.
5. To increase speed, temporarily depress the
accelerator pedal enough for the vehicle to
exceed the preset speed. When you remove
your foot from the accelerator pedal, the
vehicle will return to the speed you have set.
B660C01S-AAT
To cancel the cruise speed
Do one of the followings:
o Depress the brake pedal.
o Depress the clutch pedal (Manual transaxle).
o Shift the selector lever in “N” position (Auto-
matic transaxle).
o Decrease the vehicle speed lower than
memory speed by 12 mph (20 km/h).
o Decrease the vehicle speed approximately
to less than 25 mph (40 km/h).
o Release the main switch.
B660D01Y-AAT
To Resume the Preset Speed
B660D01Y
The vehicle will automatically resume the speed
set prior to cancellation when you push the
control switch "RESUME (ACCEL)" and re-
lease, providing the vehicle speed is above 25
mph (40 km/h).
B660E01Y-AAT
To Reset at a Faster Speed
1. Push the control switch "RESUME (ACCEL)"
and hold it.
2. Accelerate to desired speed and release the
control switch. While the control switch is
held, the vehicle will gradually gain speed.
B660F01Y-GAT
To Reset at a Slower Speed
B660B01Y
1. Push the control button “SET (COAST)” and
hold it. While the control switch is pushed,
the vehicle speed will gradually decrease.
2. When the desired speed is obtained, re-
lease the control button.
WARNING:
o Keep the main switch off when not using
the cruise control.
To Next Page
Loading...
Need help?
General
