FEATURES OF YOUR HYUNDAI
1- 48
B730A01Y-AAT
Operation Tips
o To keep dust or unpleasant fumes from
entering the car through the ventilation sys-
tem, temporarily set the air intake control at
the position. Be sure to return the con-
trol to the position when the irritation
has passed to keep fresh air in the vehicle.
This will help keep the driver alert and com-
fortable.
o Air for the heating/cooling system is drawn
in through the grilles just ahead of the wind-
shield. Care should be taken that these are
not blocked by leaves, snow, ice or other
obstructions.
B670A01A-AAT
HEATING AND VENTILATION ROTA-
RY TYPE (If installed)
B690A01Y
2
31 4
This model has four controls for the heating and
cooling system. They are:
1. Fan speed control
2. Air intake control
3. Air flow control
4. Temperature control
o Set the temperature control to the warm.
o Set the fan speed control to position 3 or 4.
NOTE:
In high humidity areas the A/C can be used
with the air intake in the position for
increased defogging action.
o Set the air intake control to the fresh ( )
position.
o Set the temperature control to the warm.
o Set the fan speed control to position 3 or 4.
ROTARY AND PUSH BUTTON TYPE
B700A01Y
To remove the interior fog on the wind-
shield;
o Set the air flow control to the defrost ( )
position. The A/C will be on automatically
and it will be changed to "Fresh" mode.
o Set the temperature control at the desired
position.
o Set the fan speed control between 1 and 4
position.
To remove the frost or exterior fog on the
windshield;
o Set the air flow control to the defrost ( )
position. The A/C will be on automatically
and it will be changed to "Fresh" mode.